Friday, December 4, 2009

Text Block Tutorial - Christmas Blocks

I put this together a few years ago for an online magazine article but realized I've never actually put it here on my blog. Here is a quick tutorial for how to make my Text Blocks (Jingle Blocks in particular).

Supplies:
Scrap wood
Scrap printed paper
Paper cutter
Acrylic paint
Mod Podge (I use Matte)
Foam Brushes
Sandpaper or belt sander



Step One: Choose your wood. The pieces I’m using are 2.75" x 3" MDF which is the exact amount left over at the end of a board after I cut out my 3" x 8" name signs. (This is how this project came about. I was determined to find a use for all the little end pieces I have lying around.)


Step Two: Choose your paper. Scrap paper is fine since the largest piece just has to be 2.5" x 2.75". I like to use several layers of somewhat related scrapbook paper. For these I used mostly vintage looking papers with Christmas themes.


Step Three: Cut the paper. For these I cut the polka dot paper to be 2.5" x 2.75" so just a bit of the wood will show on every side. The snowflake paper is cut around 1.75" x 1.5", the brocade about 1.5" x 1.25" and the letters about 1" x 1". It all just depends on your letters or words and the size of wood you are using. A paper cutter comes in handy here, but you could do it by hand.


Step Four: Paint the wood. Paint front and back and all four sides. I use acrylic craft paint because it flows well, is cheap, and dries fast.


Step Five: With a foam brush, Mod Podge the front of the block and the back of the largest paper (for these it’s the polka dot paper). Put the paper on the block and smooth down really well with your finger or a brayer or credit card. Let dry.


Step Six: With a foam brush, Mod Podge the front of the block again and the back of the next paper (for these the snowflake). Put the paper on the block and smooth down really well. Let dry.


Step Seven: With a foam brush, Mod Podge the front of the block again and the back of the next paper (for these the brocade). Put the paper on the block and smooth down really well. Let dry.


Step Eight: With a foam brush, Mod Podge the front of the block again (is this deja vu or what?) and the back of the paper with the letters on it. Put the paper on the block and smooth downreally well. Let dry.


Step Nine: With a foam brush, Mod Podge the front of the block one last time. Let dry. By Mod Podgeing every layer you’re sealing down the last layer and making the top really durable and smooth and a little shiny with the matte Mod Podge and I’d guess really shiny with the shiny Mod Podge if you use that.


Step Ten: Sand the edges if you want to. I use a belt sander, but you can do it by hand. This gives the blocks a nice distressed look.





Voila! You’re done.

If you decide to make these, send me a link so I can see!

3 comments:

  1. I love it! That makes me want to go rummage through the Hubby's shop for some wood scraps! ;-)

    ReplyDelete
  2. Great tutorial. Really well explained and photographed. Such a darling finishing project too!

    ReplyDelete

Note: Only a member of this blog may post a comment.

LinkWithin

Related Posts with Thumbnails